Bosch 15733 Powerbuilt 648691 Oxygen Sensor Offset Puller

Bosch 15733 Powerbuilt 648691 Oxygen Sensor Offset Puller

works well. cheap. use 3/8 breaker bar to loosen. warm up your engine for at least a 30 minutes,remember to use liquid wrench to loosen before. let it soak for at least 20 minutes. spray again. disconnect the wiring harness. don't let it twist. left turn to loose , right turn to tighthen. use anti siege that come with your new 02 sensor. do not get it on the o2 sensor, only the thread. 30lb torgue to tighten. (after finger thigthen, 1/ 2 turn with socket wrench it should be 30lbs).

Bosch 15733 Powerbuilt 648691 Oxygen Sensor Offset Puller

• Slotted design allows removing oxygen sensor with wiring harness attached
• Offset oxygen sensor socket provides extra leverage for easier removal even in hard to reach spots
• Precision casting for strength and accurate fit
• 7/8 inch (22 millimeter) hex fits almost all oxygen sensors
• 3/8 inch square drive for use with ratchet

Bosch 15733 Powerbuilt 648691 Oxygen Sensor Offset Puller